RAYBURN COOKERS
GENERAL QUESTIONS
THIS SECTION
OTHER SECTIONS
TURNING YOUR RAYBURN ON
Models 400K, 400G, 400L, 410K
On the 410K model ensure that the water system is filled before firing the Rayburn
The burner on this Rayburn is fully automatic in operation, under the control of its own thermostat, timer and if fitted, an external programmer.
To turn the Rayburn ON,
1. Ensure that the Oil or Gas fuel supply and electricity is turned ON to the Rayburn.
2. On later models also check that the Flue Safety Device is reset and pushed in.
3. Open controls door, top left hand side to reveal Timer and Thermostat, as shown above.
4. Set the Timer to an ON period and turn the thermostat to the desired temperature.
5. The burner should now fire and remain on until the desired temperature is reached.
7. If the burner fails to ignite, it will safely shut down and the Burner Reset Button will illuminate. Wait 3 minutes then push in the reset button and the burner will attempt another start-up. If the burner repeatedly goes to lock-out, shut the Rayburn OFF and seek help from your service engineer.
8. The Timer can perform several functions viz.
a. Minute Minder
b. Alarm up to 24hrs
c. automatic cook programme, both start & stop up to 23hr 59 mins
d. automatic finish at the end of a manually-started cook programme.
The cooker cannot be used until the Timer has been set to the correct time of day.
To use the cooker in Manual mode, press the Cooker/Stop Time Button once.
WARNING. If the burner fails to ignite or operate properly; or the burner repeatedly locks-out; or the flue safety device button trips; or if there is a smell of gas or oil fumes; or you are unsure if the cooker has been serviced recently, --- DO NOT USE --- Have the appliance checked by a qualified engineer.